ROBERTS Pressure Sensitive Flooring Adhesive Descriptions:

• Ideal for LVT/LVP, WPC/SPC, VCT/VET; all solid vinyl-backed carpet, carpet tiles and sheet goods; recycled rubber and underlayment
• Bonds with properly prepared concrete, flooring grade APA rated plywood, steel, marble, terrazzo, existing and well-bonded vinyl tile flooring (excluding self-stick), and radiant heated subfloors whose surface temperature does not exceed 85 degrees Fahrenheit
• For environmentally-controlled indoor use only
• Ultimate bond strength resists shearing and peeling
• Moisture Control Adhesive that won’t break down or emulsify when water is introduced – up to 12 lbs. MVER and 99% RH
• Up to 20 minutes open time and up to 40 minutes working time for permanent installations (wet-set method) on porous substrates only
• Up to 60 minutes tack time and up to 12 hours working time for releasable installations (tack-set method)
• Approximately 125 to 185 sq. ft. per gallon coverage when applied with a 1/16 in. x 1/16 in. x 1/16 in. square-notch trowel and 185 to 260 sq. ft. per gallon coverage when applied with a 1/16 in. x 1/32 in. x 1/32 in. U-notch trowel
• Approximately 250 to 350 sq. ft. per gallon coverage when applied with a 3/8 in. short nap roller and 90 to 120 sq. ft. per gallon coverage when applied with a 1/8 in. x 1/8 in. x 1/16 in. V-notch trowel
• When installed over existing hard surface floors, remove finish to allow a good mechanical bond
• Fresh adhesive is easily cleaned with warm, soapy water
• Excellent resistance to plasticizer migration
• Traffic – Heavy Commercial
• Enviro-friendly, solvent-free and LEED compliant; VOC 1 g/L, SCAQMD Rule 1168
• Protected by GoldGuard, an antimicrobial protection system that inhibits the growth of mold, mildew and odor causing bacteria in both wet and dry adhesives
• Non-flammable, NFPA Class A and UBC Class 1 fire resistance ratings (ASTM E84)
• CRI Green Label Plus certified – GLP #42613
• 15 year moisture control, 15 year direct bond, 7 year double bond limited warranty
• Substrate porosity test must be performed and ROBERTS 1331 Multipurpose Primer must be applied if the substrate is very porous